Note: You need to have +-3mm precision (use a metric ruler).
- If it will not go through calibration due to measurements errors, computer will store C1A00-control module fault and will be there until you go through calibration successfully.

Make sure that there are no codes stored in Ride Leveling Module.
Set a hight level to a ‘normal mode’ (middle indicator ON, others OFF)
Start a vehicle for 5 mins to make sure that air pump will pressurize the system to the required level.
Enter calibration through ‘Service Functions’.
- Once procedure has been started, it has to be completed since it clears old values from the computer’s memory.
Computer will try to set a vehicle to specific height. Wait for 1-2 mins for it to complete.
Enter measurements in mm from the center of the wheel to a fender arc
- 378mm < measurement < 597mm
After 4 measurements has been entered, car will randomly change its height for you to take a second set of measurements.
After this step has been passed successfully, calibration should be complete.

…

Body

…

…

…

…

…

…

…

…

…

…

Driver Assistance | ADAS

…

…