TPMS
General Information
- ➱ TPMS Reverse Engineering
- Usually TPMS sensors transmit only every 60 to 90 seconds
- Sensors usually aren’t required to send information until the vehicle is traveling at 25 mph or higher.
- However, many sensors transmit even when a car is idle, and some transmit even when the car is off.
- When auditing a stationary vehicle that’s powered off, be sure to send a wake-up signal (125kHz) to trigger a response from the TPMS.
Manufacturer-Specific Notes
Acura Honda
TPMS Sensor Programming
- Program sensors using TPMS Programming Tools (see above)
- If new sensor cannot be programmed, reduce tire pressure in that wheel to 5 psi and then inflate to specs. After that drive it for relearn to take place.
- After programming, drive over 25mph for less than a minute.
- TPMS sensors will start transmitting data and finish programming process.
- 📎 U3000 TPMS Unit Internal Malfunction | 2016 RDX
- Don’t replace TPMS Unit just yet
- Could be caused by a weak battery
- Reprogram TPMS Sensors and drive the vehicle
- The TPMS light might turn off (2016 RDX)
BMW (RDC)
GM
- 📎 C0569 System Configuration Error | 2008 Chevy HHR
- After reprogramming tires, perform “Tire Pressure Selection” Function
Mercedes
TPMS Deactivation
- Star ➱ Instrument Cluster ➱ Variant coding ➱ RDC
- Set everything to “NOT PRESENT” (05′ S430, 04’ SL, 03’ SLK …).
Toyota
- If the TPMS sensor cannot be programmed, try jumping pins 4 & 13 for 30 seconds (per TSB) and after removing a jumper, try programming again (2007 Camry)
- Cars with Main and Secondary switch (or menu option)
- Program BOTH sets of tires
- Note: If the main or 2nd tire set isn’t programmed, programming one tire set won’t turn off the light. You have to program both sets.
- Use odometer settings to switch from main to 2nd and vice versa (2008 Is250)
- Or use the main tire switch under the glove box (2008 RX350)
- Program BOTH sets of tires
📎 TPMS Programming | 2008 Lexus RX350
- Activate the system (without TPMS tool?)
- Make sure that a button underneath the glove box is in the ‘Main’ mode.
- Repeat this for each tire (including spare):
- Turn IGN ON and within 30 seconds deflate the next tire by at least 6psi.
- Turn IGN OFF.
- Initialize the system
- Press the TPMS reset button under the steering column and continue holding for 3 seconds after the IGN is turned ON.
VW Audi
MK60
- Go to ABS ➱ Basic Settings ➱ Group 042
- Press TPMS button (in glove box) and Traction OFF button simultaneously for 2 seconds
- After that a short tone will sound
- Press “Done, Go Back”
Disabling TPMS (🗣)
- Select ➱ 17-Instruments ➱ Adaptation ➱ Channel 61.
- Subtract 512 from whatever value you find there.